Meister TS800B Traduction Du Manuel D'utilisation Original page 83

• Use the push stick to guide the
work piece past the saw blade.
• Do not use the saw to make
grooves or folds.
• Do not use the saw for insert cut-
ting (grooves finished in the work
piece).
• Only use saw blades with max-
imum possible revolutions that
match the revolutions specified
for the saw and that are suitable
for use with the material to be cut.
• Support large/long workpieces to
reduce the risk of kickback when
the saw blade jams. Large/long
workpieces can bend under their
own weight. Workpieces must be
supported on both sides, close to
the sawing gap, and at the edge.
• When transporting the machine,
only use the transport mecha-
nisms.
• Never use the protective mecha-
nisms for handling or transporta-
tion.
• During transportation, the upper
section of the saw blade must be
covered by the protective hood.
1. Only use a saw blade with a
diameter corresponding to the
information on the saw
2. Only use saw blades, which are
labelled with a rotation speed
of the same size or higher than
that of the power tool.
3. Do not make longitudinal cuts
with an incline on the side
where the incline leads.
MW-5461570-Bedien-2003.indd 83 MW-5461570-Bedien-2003.indd 83
CAUTION! Switch off saw
immediately and pull out plug
if
• the power feed lead and
switch are damaged,
• the saw is overheating,
• smoke is emitted or there
is a smell of charred insu­
lating material.
Safety marking
The symbols on the housing mean
the following:
Important! Observe oper-
ating instructions!
Material saw blade /
HW 24 Z.
Number of teeth
Tooth shape / Position
Tooth shape / Position
suitable for plywood
Wear gloves
„Tested Safety" voluntary
quality mark
CE Mark (conformity to
European safety stand-
ards)
Wear safety goggles!
Wear ear defenders!
Wear a dust protection
mask.
83
04.05.20 16:46 04.05.20 16:46