Charging A Battery; 1Preparation - APA 16623 Manuel De L'opérateur

Figure 3: Control lamps for operating status
Figure 4: Operating panel function selection
Figure 5: Operating panel for generator test

6.2 CHARGING A BATTERY

6.2.1 PREPARATION
Clean the battery terminals to remove dust and corrosion residue.
Only for open batteries: Remove the plugs of the battery cells. Replenish distilled water up to the minimum fill
level. Leave the cells of the battery open until the end of the charging process.
With maintenance-free batteries, follow the instructions of the battery manufacturer precisely.
12
3.1 Charge, the battery is being charged
3.2 Full, the charging procedure is complete
3.3 Repair (program for desulphation)
3.4 Error, no battery, defective battery,
incorrect voltage selected
3.5 Inverse, battery terminals connected incorrectly
4.1 Selection switch for charge current 2, 10, 20,
Auto (0-20) [A]
4.2 Selection switch for battery type Standard,
GEL, AGM
4.3 Selection switch for operating mode,
6V charge, 12V charge, jump-start 12V,
constant-current source 13.6V
5.1 Control lamp for generator error
5.2 Control lamp for generator OK
5.3 Switch generator test ON