Explanation Of Symbols; Operating Instructions; Overview - APA 16623 Manuel De L'opérateur

tery acid gets into the eyes, immediately rinse under running water for at least 10 minutes and
consult a doctor.
• Do not cover the charger and keep the ventilation slots free, otherwise this may result in overhea-
ting and in damages. Never set the charger up for operation on a surface that is insulating (e.g.
polystyrene). There is a risk of heat built up!
• If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the
parking break and switch off the ignition. Cut the battery off from the on-board network of your
vehicle. To do this, read the manual of your vehicle or ask your specialist workshop.
• When pulling the mains cable out of the socket, only hold the plug.
• Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
• Store these instructions carefully and, if necessary, pass them on to other users.

5. EXPLANATION OF SYMBOLS

Complies with
EC directives
Insulated housing
(protection class II).
Read the operating
instructions

6. OPERATING INSTRUCTIONS

Before using the device make sure that you have read the operating instructions for the battery and the
vehicle and you have understood all of the safety precautions.

6.1 OVERVIEW

Bild 1: Bedienfeld
Figure 2: Display settings
Labelled electrical products
may not be disposed of in
the household waste
Fuse, here: Slow-burning,
1.6 A
Corresponds to the require-
ments of § 21 of the German
Product Safety Law
(Produktsicherheitsgesetz)
2.1 Display charge voltage in Volt
2.2 Display charge current in Ampere
2.3 Display charge progress in percentage
2.4 Selection switch
Devices with this symbol may
only be operated in the house
(dry environment)
Recommended battery capacity
1 Display
2 Displayeinstellungen
3 Betriebszustandsanzeige
4 Funktionseinstellungen
5 Lichtmaschinen-Test
6 Start- Stop-Taste
11