Charging The Battery; Selecting The Charging Programme - APA 16619 Manuel De L'opérateur

6.5 CHARGING THE BATTERY

Connect the adapter charging cable to the charging cable
(Position D in the overview) of the battery charger. Now
connect the mains connection cable (Position A in the
overview) of the battery charger to the power socket. The
background illumination of the display is activated.
If the battery has been connected incorrectly (wrong
poles) or the charger has no contact, the following error
message appears on the display ˝Er1˝. If the error message
˝Er2˝ is shown, a defective 6 V battery has been connected,
this cannot be charged using the battery charger. If the
battery has been correctly connected, the display shows the
current battery voltage and the symbol for the set charging
programme.
CAUTION
After plugging the mains cable inselect the
desired charging pro- gramme by operating
the MODE button multiple times. If the MODE
button is not pressed, the charging process is
not started. When charging has started it is no
longer possible to switch to another charging
program, If you wish to work with a program
Possible charging programmes
6 Volt mode
Charging programme for 6 V batteries, 1.2 Ah to 14 Ah, temperatures above 0°C
Charge current:
Charge voltage:
6 Volt winter mode
Charging programme for 6 V batteries, 1.2 Ah to 14 Ah, temperature below 0°C
Charge current:
Charge voltage:
Motorbike mode
Charging programme for 12 V batteries from 1.2 Ah to 14 Ah, temperatures above 0°C
Charge current:
Charge voltage:
Motorbike winter mode
Charging programme for 12 V batteries from 1.2 Ah to 14 Ah, temperatures below 0°C
Charge current:
Charge voltage:
Car mode
Charging programme for 12 V batteries from 14 Ah to 120 Ah, temperatures above 0°C
Charge current:
Charge voltage:
Car winter mode
Charging programme for 12V batteries from 14 Ah to 150 Ah, temperatures below 0°C
Charge current:
Charge voltage:
Battery maintenance charge mode
As soon as the battery is fully charged, the charger switches automatically over to battery
maintenance charge mode. This is indicated appropriately on the display.
10
2 A maximum
7.2 V
2 A maximum
7.4 V
2 A maximum
14.3 V
2 A maximum
14.8 V
4 A maximum
14.6 V
5 A maximum
14.8 V
other than the set charging program, pull the
plug out of the socket and wait until the display
has gone dark. Then insert the plug again and
proceed as described above.

6.5.1 SELECTING THE CHARGING PROGRAMME

By pressing the MODE button (multiple times), you can
select the appropriate charging programme for your needs.
The charging programmes appear in the following order
and may be selected by pressing the MODE button:
Motorbike 6 V Motorbike 6 V winter
Motorbike 12 V Motorbike 12 V winter
Car 12 V Car 12 V winter
Depending on the charging state of the battery, the device
adapts the charging current in order to best charge the
connected battery. The specifi ed maximum charging cur-
rent is only used during the main charging phase. Shortly
before the full charging capacity is achieved, the device
switches to a lower charging current. This ensures that the
battery is gently and optimally charged to full capacity.
The battery symbol (Position 7 in the overview) shown on
the display indicates the current fi lling level of the battery.