Connecting The Adapter Charging Cable; With Eyes; Charging The Battery; Selecting The Charging Programme - APA 16633 Manuel De L'opérateur

6.4.2 CONNECTING THE ADAPTER CHARGING CABLE

WITH EYES

CAUTION
Make sure that the charger is not connected to
the power socket and that the adapter charging
cable is not connected to the battery charger.
Attach the eye of the red plus cable to the plus connection
cable of your vehicle battery, e.g. the screws of the pole
terminal. Attach the eye of the black minus cable to the
earth connection cable (minus cable) of your battery. Lay
the cable so that it is free from bends and tensions. It may
not be attached in the vicinity of hot or rotating parts of the
motor. The connection plug may not get wet.
When using the adapter charging cable with the
ring eyes, switch all consumers in the vehicle off
before starting the charging process. Never leave
the charging process unattended.

6.5 CHARGING THE BATTERY

Connect the adapter charging cable to the charging cable
(Position D in the overview) of the battery charger. Now
connect the mains connection cable (Position A in the
overview) of the battery charger to the power socket. The
background illumination of the display is activated.
If the battery has been connected incorrectly (wrong poles)
or the charger has no contact, the following error message
appears on the display ˝Er1˝. If the error message ˝Er2˝
is shown, a defective 6 V battery has been connected,
this cannot be charged using the battery charger. If the
battery has been correctly connected, the display shows the
current battery voltage and the symbol for the set charging
programme.
CAUTION
After plugging the mains cable inselect the
desired charging pro- gramme by operating
the MODE button multiple times. If the MODE
button is not pressed, the charging process is not
started. When charging has started it is no
longer possible to switch to another charging
program, If you wish to work with a program
other than the set charging program, pull the
plug out of the socket and wait until the display
has gone dark. Then insert the plug again and
proceed as described above.

6.5.1 SELECTING THE CHARGING PROGRAMME

By pressing the MODE button (multiple times), you can
select the appropriate charging programme for your needs.
The charging programmes appear in the following order
and may be selected by pressing the MODE button:
Motorbike 6 V Motorbike 6 V winter
Motorbike 12 V Motorbike 12 V winter
Car 12 V Car 12 V winter
Depending on the charging state of the battery, the device
adapts the charging current in order to best charge the
connected battery. The specified maximum charging current
is only used during the main charging phase. Shortly before
the full charging capacity is achieved, the device switches
to a lower charging current. This ensures that the battery is
gently and optimally charged to full capacity.
The battery symbol (Position 7 in the overview) shown on
the display indicates the current filling level of the battery.
11