Entering The Welder Id Code; Entering Or Changing The Commission Number - Hürner CNC ECO 355 2.0 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
enter them before the welding process proper. Depending
on what data is entered, either its repeated input is man-
datory (e. g., the welder ID code; see Sect. 4.2.1) or previ-
ously entered data can be changed and confirmed or con-
firmed without changes (e. g., the commission number; see
Sect. 4.2.2).
For the input of data, an alphanumeric keypad is
provided. It is designed and works like the keypad of
a common mobile phone without touch screen dis-
Info
play. All characters found on a key can be "browsed"
by pressing that key repeatedly at short intervals. As
soon as "browsing" generates the desired character
on the screen, wait a little longer until you press
the next key to use the displayed character. The first
character always is the number on the respective
key, then the letters or marks in the order on the
key, i. e., for instance, with the key "2 | a | b | c" the
1 keypress brings up "2," the 2
st
and the 4
th
ters appear on the screen. To enter upper-case let-
ters, hold down the ñ key while selecting the ap-
propriate letter by one or several keypresses.
4.2.1

Entering the Welder ID Code

When the welding is started by pressing the START/SET key
while Display 3 is showing, first the input of the welder
identification code is requested, if it is enabled in the con-
figuration menu (see Display 11). The code has to be an ISO-
compliant code. It can be entered either using the alphanu-
meric keypad (refer to the Info at the beginning of Sect. 4.2)
and confirming the input by pressing the START/SET key, or
by reading a RFID transponder card or scanning it from a bar
code with the optional handheld scanner.
When the code was properly scanned or entered, this is con-
firmed by an audible signal.
4.2.2

Entering or Changing the Commission Number

From Display 3 or after the welder identification code was
entered, the machine requests the input of the job num-
ber, or commission number, of a maximum 32 characters, if
it was enabled in the configuration menu. If a commission
number exists already in memory, this one is proposed. You
can either confirm it by pressing START/SET or change it us-
ing the alphanumeric keypad (refer to the Info at the begin-
ning of Sect. 4.2) or reading it with the scanner or from a
RFID card and then confirm the new number by pressing the
START/SET key.
It is possible to select a previously saved commission number
instead of the one shown on the screen by pressing the ï
Version October 2022
brings up "c." By default, lower-case let-
HÜRNER CNC ECO 355 2.0 User's Manual
"a," the 3 "b,"
nd rd
Enter Welder Code
++++++++++++++++++++
++++++++++
Display 11
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 12
EN
19