Beta 3070BE/K Mode D'emploi page 30

INSTRUCTIONS FOR USE
EN
Err. 3 Unbalance too high.
Err. 4 Rotation in opposite direction.
Err. 7 NOVRAM parameter read error
Err. 8
Err. 9
Err. 11 Speed too high.
Average spin speed is >240 rpm.
Err. 14 Unbalance measurement error.
Err. 15
Err. 16
Err. 17
Err. 18
Err. 19
Err. 22 Maximum number of spins possible
for unbalance measurement has
been exceeded.
Err. 23 Wheel does not slow down
Err. 24 Distance between spokes <18
degrees.
Err. 25 Distance between spokes >120
degrees.
Err. 26 First spoke too far from unbalance
MAINTENANCE
This machine has been designed so as not to require routine maintenance, apart from accurate periodic
cleaning. It is important to keep the machine perfectly clean, in order to prevent dust or impurities from affecting
the operation of the wheel balancer.
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta
Untensili S.P.A.'s repair centre.
30
1. Check the wheel dimensions setting.
2. Check the detection unit connections.
3. Mount a wheel with more or less known unbalance (<100 grams)
and check the response of the machine.
4. The CPU board may have broken down.
1. Use the self-diagnostics function to check the encoder.
2. Check the encoder bearing/spring.
1. Switch off the machine; wait for at least ~ 1 min;
Restart the machine and check that it works properly.
2. Repeat machine calibration..
3. The CPU board may have broken down.
1. Use the self-diagnostics function to check the encoder.
2. The CPU board may have broken down.
1. Use the self-diagnostics function to check the encoder.
2. Check the detection unit connections.
3. Check the machine earthing connection.
4. Mount a wheel with more or less known unbalance (<100 grams)
and check the response of the machine.
5. The CPU board may have broken down.
1. Check that a vehicle wheel has been mounted on the wheel
balancer.
2. Use the self-diagnostics function to check the encoder.
3. The CPU board may have broken down.
1. Remember to release the spinning device when the displays go
off.
2. Use the self-diagnostics function to check the encoder.
3. The CPU board may have broken down.
1. The minimum distance between the spokes where the unbalance
is to be split must be greater than 18 degrees.
2. Repeat the SPLIT function, increasing the distance between the
spokes
1. The maximum distance between the spokes where the unbalance
is to be split must be less than 120 degrees.
2. Repeat the SPLIT function, decreasing the distance between the
spokes.
1. The maximum distance between the unbalance position and the
spoke must be less than 120 degrees
2. Repeat the SPLIT function, decreasing the distance between the
spoke and the unbalance.