Beta 3070BE/K Mode D'emploi page 18

INSTRUCTIONS FOR USE
EN
• Check that the wheel balancer is fixed firmly.
• Before operating the wheel balancer, check that no foreign bodies are found on the moving parts.
• Do not modify the frame of the machine in any way.
• Carry out extraordinary checks following any particular events that may have damaged the wheel balancer,
thereby affecting proper operation.
• For any maintenance and repair jobs, please contact Beta Utensili S.p.A.'s repair centre. Only original spare
parts may be used.
• Replace any damaged plates, stickers, transfers or other warnings on the machine.
WHEEL BALANCER USE AND CARE
• Make sure that the component parts of the wheel balancer have been connected properly.
• Check that the mains voltage and frequency are compatible with the data on the plate.
• Check that the mains cable has been connected properly.
• Check that both the shaft and the flange are clean.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING WHEEL BALANCER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY FOOTWEAR WITH PROTECTIVE TOE CAPS
ALWAYS WEAR MECHANICALLY RESISTANT PROTECTIVE GLOVES
ALWAYS WEAR EYE PROTECTION
WEAR WORK CLOTHING
The above-mentioned personal protective equipment refers to the use of the wheel
balancer in standard work environments. If any hazardous situations are shown following
specific surveys, it must be supplemented with such equipment as described in the risk
assessment document, in compliance with current standards concerning safety in the
workplace.
18