Beta 3070BE/K Mode D'emploi page 24

INSTRUCTIONS FOR USE
EN
Use the arrows to set DISTANCE "a" (in mm) between the inner side of the wheel and the machine (red line on
the display), using the rule supplied with the wheel balancer.
The display will show the parameter that is being set on the left and the value of such parameter on the right
respectively (see figure):
1. Use the arrows to set WIDTH "b", which is usually stated on the rim; alternatively, use the calliper gauge
supplied with the wheel balancer.
2. Use the arrows to set rated DIAMETER "d", which is stated on the tyre.
3. After setting these parameters, turn the wheel manually, using the knobs of the lock nut.
4. The display will no longer show any light and the stop signal will be displayed; the wheel will then have to be
stopped manually, as the unbalance reading has been completed.
5. Balance the wheel with the weights as explained in the section "MEASUREMENT RESULT".
Wheels with correction internal to rim
Press until the LEDs shown in the figure light up:
Enter the values of aI, aE
Enter the required measurements into the wheel balancer, in the diagram below:
aI ►measure with the supplied rule and enter the value by pressing
aE ►measure with the supplied rule and enter the value by pressing the key
d ►measure with the outer points of the gauge and enter the value by pressing
dE ►measure with the outer points of the gauge and enter the value by pressing for 2 seconds
then press the keys
24