Beta 3070BE/K Mode D'emploi page 25

Les langues disponibles

INSTRUCTIONS FOR USE

EXAMPLE

MEASUREMENT RESULT

Move the wheel manually until all the LEDs corresponding to the side being inspected light up.

The display shows the measured unbalance, and thus indicates the weight to apply to the point shown by the

arrow in the drawing below

Pressing

the keys allows the positions of the weights to be selected. For each position, the display

will show the value of the weight to apply.

For unbalance within tolerance 0 (zero) is displayed;

allows the values within tolerance to be viewed.

SPLIT FUNCTION (hidden adhesive weight)

The SPLIT function is used to place the adhesive weights behind the wheel spokes, so that they are no longer

visible (for alloy rims).

NB: This function is applicable to spokes whose angles range between 18° and 120°; for angles outside this

range, errors 24, 25 or 26 will occur (for a detail description of errors, see section "DIAGNOSTICS"). Spokes

with irregular or inconsistent angles can be compensated.

Use this function

in the mode if an adhesive weight is expected to be applied inside the rim.

Enter the wheel dimensions and turn the wheel manually.

1. Turn the wheel to the outer side unbalance correction position.