Beta 3070BE/K Mode D'emploi page 22

INSTRUCTIONS FOR USE
EN
HOW TO USE WHEEL BALANCER
STARTING AND WHEEL INSTALLATION
• Insert the power supply plug into the mains socket.
• Start the wheel balancer by pressing the switch on the bottom of the machine.
• Place a cone suitable for the wheel hole.
• Place the wheel on the terminal with the inner part facing the wheel balancer.
• Tighten by means of the lock nut (see drawing), until the wheel is locked to the flange.
Before operating the wheel balancer, visually check it for foreign bodies in the moving parts.
RESIDUAL RISKS
Residual risk' means a potential risk impossible to eliminate or partially eliminable, which may cause injury to
the operator if operating using improper working methods and practices.
Pay attention to the position of your hands in the areas indicated in the figure, as there is a risk of crushing
your fingers during wheel locking on the spindle.
While mounting or dismounting the tyre, pay attention to avoid accidentally crushing your feet.
22