Beta 3070BE/K Mode D'emploi page 26

INSTRUCTIONS FOR USE
EN
2. Move one of the spokes to 12 o'clock (ex. 1) and press
3. Following the direction of rotation indicated by the position LEDs, move spoke 2 to 12 o'clock and press
The value to use for correction in position 2 will be displayed.
4. Move spoke 1 to the correction position as indicated by the position LEDs.
To go back to the normal unbalance indication, press any button.
UNBALANCE OPTIMISATION
This operation is performed to reduce the static unbalance of the wheel.
It is suitable for static unbalance values in excess of 30 grams.
► ►
1. If no unbalance was measured before, START appears on the display;
alternatively, move on to subsection b.
Perform a manual spin
2. Make a reference mark on both the flange and the rim (e.g. using a piece of chalk). Use a tyre remover to
turn the tyre on the rim by 180°. Refit the wheel in such a way that the reference marks on the rim and the
flange coincide.
Perform a manual spin
3. Right display: percent reduction value Left display: current static unbalance value which
can be reduced by rotation.
26