Installation And Final Inspection; Use Of Eco Hot Water; Unit Power Supply - emmeti EQ 2018 Manuel D'installation Et D'utilisation

5. INSTALLATION

5.9 Installation and final inspection

Explain to the customer the correct use of the apparatus.
VERIFICATION OF THE COMPONENTS OF THE INSTALLATION
As each component is checked, place a check mark in
The conditions for selecting of the installation location are met?
The voltage of the electrical power corresponds to the specification?
The connecting cables are connected in a safe manner?
The earth cables are connected in a safe manner?
The equipment and the connecting sections of main pipes are free of
leaks of the circulating water?
The connecting sections of the pipes are thermally insulated?
TESTING
When you turn on the control panel error or protection codes are not
displayed.
Is adjustment of the temperature and other functions used possible.
The system is free of strange noises?
6. USE OF THE ECO HOT WATER

6.1 Unit power supply

After power has been supplied to the unit the display is illuminated and all
of the icons on the display appear.
The following screen or similar appears briefly indicating the software
version
Then the unit shows the following screen.
When you see the word OFF , the unit is turned off.
The time is visible and has been set correctly by the user.
Above the word OFF appears one of the modes of operation available:
HEATING
INTELLIGENT
Under the word OFF there are 6 touch sensitive keys. If no key is touched,
after about 1 minute the display dims to save energy. To be able to see
what displays are available touch any key once. When a key is touched the
unit emits an acoustic signal (beep!).
ECO-HEATING
HOLIDAY
Final checks
DANGER
• After installation, check that there are no refrigerant gas leaks.
• In case of gas leaks during installation, immediately aerate the
room.
• If there is a loss of refrigerant gas indoors and near a heat source,
such as a stove, poisonous gas can be generated.
Contact the service desk if you
find one of the events described below
• Power Cord overheated or damaged;
• Unusual noises during operation;
• Frequent functioning of the protection devices;
• Unusual smells (such as the smell of burning).
min
SET
TEMP
GB GB
GB GB
51