emmeti EQ 2018 Manuel D'installation Et D'utilisation page 60

6. USE OF THE ECO HOT WATER
Setting the temperature value for the water
You can choose a set temperature of the water between 10 °C and 60 °C
with variations of 0.5 °C.
On the main screen press or
perature.
Press or to change the temperature value.
TEMP
TEMP
Activation of the heat pump
In HEATING and ECO-HEATING modes, when the BTT temperature drops
below the set value minus the differential (r03), the set value reached
icon disappears and the compressor of the heat pump starts.
Upon reaching the set value, the set value reached icon appears and the
compressor will stop.
Activation of the electric heater
In HEATING mode, the electric heater is automatically turned on.
It is also possible to manually turn on and off in all operating modes, even
with the unit OFF.
In any case, the electric heater will operate only if the temperature TTT
is lower than the set value minus the differential (r03) and will turn off
automatically when the set value is reached.
Pressing the key manually activates the electric heater, pressing
again turns it off.
60
once to display the current set tem-
Touch 1 time
or
to control the
temperature
set
Touch
for confirm
or
to cancel and
return to the screen
previous
After you have set the temperature value setting of the water, press
to confirm or to cancel the changes and return to the previous screen.
If the keypad is not used for at least 5 seconds, the set values will be
automatically confirmed and the main screen is displayed.
For example: set the desired temperature setting of the water from 50
°C to 55.5 °C .
Set temperature for the water
SET
Press or to chance
the temperature imposata
SET
TEMP
Set
satisfied
TEMP
GB GB
Electric Heater