Hydraulic Modules Installation; Installation Of Box Assemblies; Installation Of Single Modules - emmeti Energy box Manuel D'installation Et Mode D'emploi

3. HYDRAULIC MODULES INSTALLATION

3.1 Installation of box assemblies.

- Adjust the feet of the box using the 2 clamp screws so that there is at least
a 25 cm gap between the lower collectors and the floor. This will make it
easier to correctly fold the distribution pipes.
- Fix the box to the wall with cement, first applying the mortar cover
carton as shown in the figure below.
Coperchio di protezione per intonaci
Plaster protection cover
Tapa de protección para el enyesado
A
Dado ad alette
Fly nut
Tuerca de mariposa
Emmeti Spa - 33070 Vigonovo di F.dda (Pn) - Via B. Osoppo, 166 - Italy - Tel. 0434567911 - Fax 0434567901 - www.emmeti.com
CAUTION
In order to make the hydraulic connections, you must first remove
the servomotor from the brass body of the motorized valve.
20
40
20 60
0 80
B C
40 40
20 60 20 60
0 80 0 80
Nastro adesivo Profilo cassetta
Tape Profile box
Cinta adhesiva Perfil de la caja

3.2 Installation of single modules.

The single modules which are not in a box can be installed directly on
the wall, in a wall-unit configuration, by fixing the brackets with suitable
plugs and screws (to be selected based on the structural type of the
wall).
In any case, the single modules are supplied complete with plugs and
spacers to facilitate the wall fastening procedure.
CAUTION
In the models with 4-way motorized valve, before fixing the
assembly to the wall and making the hydraulic connections, make
certain that the butterfly handle of the ball valve with by-pass can
turn completely without striking the fixing bracket.
CAUTION
In the models with 2-way motorized valve, before making the hydrau-
lic connections, make certain that the servomotor is inclined enough
to allow installation at a later time of the energy meter in place of the
steel infill valve.
GB GB