emmeti EQ 2018 Manuel D'installation Et D'utilisation page 54

6. USE OF THE ECO HOT WATER
Setting the time and date
With the unit in the OFF position or in operation, by pressing the key
, the hours and minutes flash. Continued pressing of
hours blink.
With the
e keys, the actual hour can be set. Press
to confirm the hour, and set the minutes that are flashing with the
and keys,then press to confirm the value.
If the keypad is not used for about 6 seconds, the set values that are
flashing will be automatically confirmed and then the main screen is dis-
played.
Immediately after you have modified the minutes, pressing
make the month and day flash. Perform the same procedure used to set
the time and minutes.
Pressing again flashes the year for example 2010.
Pressing again will flash the last 2 digits, and with the
keys, set the current year.
To cancel a setting, press the
TEMP
TEMP
Touch 1 time then push
set the month and push to confirm.
TEMP
54
will make the
again
and
key when the value to edit flashes.
Hour
Touch 2 times
then push
or
to set the current time
push
to confirm
The date is blinking
Push
to confirm
or for
Touch
or
to set the day
For example:
Change the date and time from 18:30 on 4th August to 5:40 PM on the
8th September.
If the HOURS and MINUTES, are already correct, when they flash at the
same time press
YEAR.
will
TEMP
Touch or to set the minutes
TEMP
TEMP
Touch to confirm the current hour set
TEMP
or to go directly to the MONTH and DAY or
GB GB