Cutting Grass; Vertical Cutting / Edge Trimming; Cleaning And Maintenance; Cleaning - Grizzly ERT 530 R Traduction De La Notice D'utilisation Originale

Masquer les pouces Voir aussi pour ERT 530 R:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
GB

Cutting grass

Long grass should be cut at layers from
top to bottom.
To make your work easier, you
can use the chassis to work along
lanes similar to a lawn mower.
The chassis is intended for larger
lawns to avoid having to carry the
appliance the whole time.
Vertical cutting / edge
trimming
Be particularly careful and attentive
when holding the cutter head verti-
cally. To avoid injuries, keep enough
distance to the cutting thread.
To prevent the thread from wearing out
quickly, avoid contacting solid surfaces.
To trim lawn edges, slowly move the
appliance along the lawn edges.
Vertical trimming is best done by mov-
ing the appliance on its castor roll.
You can also tip the chassis to the left
or right and use it as a guide for edge
trimming.
Setup for vertical trimming
without chassis:
• Handle rod: 180° (see
• Cutting angle: position 1
F
(see
• Spacer bow in parking position
• No chassis
106
Cut the grass by
swaying the
trimmer side-
ways to the right
and left. Cut
slowly, tipping
the appliance
slightly fowards .
F
ƒ
)
Setup for edge trimming with
chassis:
• Handle rod: 90° (see
• Chassis tipped to one side
• Cutting angle: position 4
(see
• Spacing bow in parking position
Cleaning and
maintenance
Always disconnect the plug
from the mains socket before
working on the trimmer.
Any work that is not described
in these Instructions must be
carried out by a servicing agen-
cy authorized by us. Only use
original parts and be very care-
ful with the line cutter during in-
stallation work. Danger of injury!

Cleaning

Do not jet water onto the trim-
mer and do not clean it under
flowing water. This would result
in the danger of an electric
shock and the trimmer could be
damaged.
Always keep the trimmer clean. Do no
use cleaning agents and solvents.
After the work has been completed
remove all grass and soil from the cut-
ting device and the protective cover.
Ensure that the ventilation slots are
always clean and free of grass.
)
Clean the trimmer with a soft brush or
a cloth.
F
ƒ
F
)
)

Publicité

Table des Matières
loading

Table des Matières