Assembling Instructions - Grizzly ERT 530 R Traduction De La Notice D'utilisation Originale

into the equipment increases the
risk of electric shock.
• Avoid body contact with earthed
parts (e.g. metal fences, metal
posts). There is an increased
risk of electric shock if your body
is earthed.
• Only use extension cables
with a maximum length of 75
m that have been approved
for open-air use. The stranded
cord diameter of the extension
cable must be at least 2.5 mm
Always unreel a cable drum to
its full length so that the entire
cable can be inspected for dam-
age.
• Never pass an operating equip-
ment over the extension cable.
Ensure that the power cable is
always trailing behind the op-
erator. The extension cable can
be accidentally severed.
• Use the envisaged cable sus-
pensions when attaching an
extension cable.
• Never carry the equipment by
its power cable. Never pull the
cable to disconnect the plug
from the mains socket. Protect
the cable from heat, oil and
sharp edges. The mains power
cable could be damaged.

Assembling instructions

Always disconnect the plug be-
fore working on the trimmer and
wait until the cutting lines have
completely stopped. There is the
danger of electric shock and the
possibility of injury by the cut-
ting lines.
Use OEM parts only and mind
the thread cutter during assem-
bly. Risk of injury!
Assembling the protection
cover:
1. Put on the safety cover (14),
making sure to match the two
triangular marks.
Check that the cutting threads
are not caught.
2. Use the longer screw from the
.
2
package to secure the cover.
3. Use the three screws from the
package to to mount the cas-
tor roll (17) to the bottom of the
safety cover.
Mounting the additional
handle:
1. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle rod
discs (20).
2. Screw down the auxiliary handle.
To mount the chassis:
The chassis attaches to the tel-
escopic shaft.
1. To extend the telescopic shaft,
loosen the threaded bush (9),
push or pull the shaft (10) to the
desired length, and tighten the
threaded bush again.
2. Place the chassis (13) on the
telescopic shaft (10).
3. Attach the chassis with screws.
GB
103