Working With The Hedge Trimmer; Cutting Techniques; Cleaning And Maintenance - Grizzly AHS 1852 Lion Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
Working with the Hedge Trim-
mer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage
to the cutter bar.
Switch off the equipment immedi-
ately in the event that the blades are
blocked by solid objects, pull out the
power plug then remove the object.
Avoid overstraining the equipment
during work.

Cutting Techniques

Cut thick branches beforehand using
a branch clippers.
The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge,
so that cut branches fall to the ground.
In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
Cutting Shaped Hedges:
30
It is recommended
that hedges be cut
in a trapezoidal
shape, in order to
prevent stripping off
of the lower branch-
es. This corresponds
to the natural plant growth and allows the
hedge to thrive optimally. During cutting, only
the new annual growths are reduced and
thus a dense branching and a good screen
will develop.
Cut the sides of a hedge first. To do
this, move the hedge trimmer in the
direction of growth from bottom to top.
If you cut down from the top, the thin-
ner branches will move out, which may
result in some areas having sparse
growth or holes.
Cut the top edge, according to taste,
in a flat shape, roof shape or rounded
shape
Trim young plants to the required
shape. The main growth should re-
main undamaged until the hedge has
reached the planned height. All other
shoots are lopped off to half size.
Care of Free-Growing Hedges:
Free-growing hedges are not shaped when
cut, although they must be regularly main-
tained so the hedge does not become too
high.

Cleaning and Maintenance

Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Turn off the appliance and, before
doing any servicing, remove the
battery.
Wear gloves when handling the
safety knife bar. This will protect
you against cuts.

Publicité

Table des Matières
loading

Table des Matières