Fitting The Two-Part Tube; Fitting The Handle; Installing/Removing The Metal Cutting Blade - Grizzly MTS 43 AC E2 Mode D'emploi

GB

Fitting the Two-Part Tube

(Picture 3)
1. Remove the protective transport cap
(29) from the bottom shaft tube (13).
2. Loosen the tube fixing screw (12) on
the top shaft tube (10).
3. Plug the two shaft tubes (10 + 13) into
each other so the safety button (30)
clicks into the notch provided for it in
the top shaft tube.
4. Retighten the tube fixing screws (12).
pic. 3
29
13
Ensure that the bottom shaft tube
is sitting firmly and safely before
starting the equipment.
5. Dismantling:
Loosen the tube fixing screw (12).
Press the safety button (30) and pull
the tubes apart
Fitting the Handle (Picture 4)
1. Loosen the 4 Allen screws (31) on the
top shaft tube (10) and take off the
handle holder (32).
2. Place the multifunction handle (11) in
the handle slot on the top shaft tube
(10) and fix it using the handle holder
and the 4 screws.
3. Fix the accelerator cable (8):
With the large cable clamp (9) on the
top shaft tube (10);
120
10
12
30
With the small cable clamp (21) on the
multifunction handle (11).
Ensure that the accelerator cable
(8) is not twisted or kinked.
pic. 4
21
32
31
Installing/Removing the Metal
Cutting Blade
Wear protective gloves when han-
dling the metal cutting blade.
Dismantling the reel capsule is
described in the section on "Install-
ing/Removing the Reel Capsule".
Installing the protective cover / metal
cutting blade (picture 5):
1. If applicable, unscrew the top (33b)
and bottom (33a) flanges mounted on
the cutting head holder (19).
2. Screw the protective cover (15) onto
the cutting head holder (19) using the
3 screws (34) enclosed.
Installing the metal cutting blade
(picture 5):
3. Place the metal cutting blade (18) and
flanges (33a+b) on the cutting head
holder (19) in the following order:
Bottom flange (33a) – metal cutting
blade (18) – top flange (33b).
8
9
10
11