Sony DKR-700 Mode D'emploi page 34

Image Data Management (Using the RM-C700)
4
Enter the desired number (up to 15 digits).
Each time a digit is entered, the cursor will move
one position to the right.
ID No:13479
Mode:Off
[ ] Select [EXEC] End Mm
5
Using the or key, move the cursor to the
≥
˘
"Mode".
ID No:13479
Mode:Off
[ ] Select [ ] Set
µ Mm
6
Using the or key, change the setting to Hold
¿ ÷
or Inc.
Hold: Use this ID number for all images recorded
until a new ID number is set.
Inc: Each time a new image is recorded,
increment the ID number and attach it to that
image.
To disable recording of ID numbers
Set the "Mode" to Off.
7
Check the entered ID number and the Mode
setting, and press the EXE key if they are correct.
Note
The ID set is lost when the unit is powered off.
Modifying a recorded ID number
1
Play back the image whose ID number is to be
changed, using the procedures in "Playing or
Searching for Images" (page 26(E)).
Notes
• Be sure the disc is not write-protected.
• Play back the image with some mode other than
auto play. ID numbers may not be changed while
in auto play mode.
34(E)
2
Press the ID NO key.
The ID number rewrite display appears.
[Rewrite]
ID No:12345678
[ ] Select [EXEC] End
Mm
3
Press the or key to display the cursor and
¿ ÷
move it to the position where digit is to be
changed.
[Rewrite]
ID No:12345678
[ ] Select [EXEC] End Mm
4
Enter the desired digit.
[Rewrite]
ID No:12345978
[ ] Select [EXEC] End Mm
5
Press the EXE key.
Note
Once an ID number has been recorded, it can be
changed, but cannot be erased.