Activating The Dkr-700/700P And Inserting/Removing Discs - Sony DKR-700 Mode D'emploi

Preparation
Protecting against accidental erasure
When more data is written to a previously recorded
(full) disc, the older data may be lost. To guard
against accidentally erasing important data, slide the
write protect switch as shown in the illustration.
Write-protect switch
When a write-protected disc is inserted into the DKR-
700/700P, recording operations will not be able to be
performed. In order to re-record a disc, return the
write protect switch to its original position.
Labeling discs
Attach the supplied label to the disc, and make a note
of the disc's contents. If the label is full, remove the
old label and affix a new one. If new labels are affixed
on top of old labels, or if the label is not aligned in its
proper position, malfunctions may occur, and the
disc drive may be damaged.
18(E)
Label (supplied with the disc)
Activating the DKR-700/700P and
Inserting/Removing Discs
POWER switch
POWER indicator
Activating the DKR-700/700P
Turn the POWER switch on.
The POWER indicator lights and the DKR-700/700P
starts.
After a few seconds, the SOURCE button lights, and
the keys on the front panel go into effect. The DKR-
700/700P beeps if the "Beep" in the System Setup
menu is set to On.
For information on enabling the beep sound, see page
46(E).
The POWER switch may be turned on or off while a
disc is loaded.
Inserting a disc
Holding a disc with the arrow side up, insert it in the
slot in the direction of the arrow.
Note
The orientation of a MiniDisc is different from that of
a floppy disk or MO disc.
When activating the DKR-700/700P, the BUSY
indicator lights and the DKR-700/700P starts to check
the data on the disc.
Disc slot
BUSY indicator
EJECT button
Disc