Sony DKR-700 Mode D'emploi page 42

Menu Operations
To change the setup values
1
Move the cursor to the desired item using the
button/key.
≥
2
Change the setting using the
The settings for each item are as follows:
Quality: Used to select the quality of image
recording.
Non Comp: Recording uncompressed images
Fine: Recording high-quality images
Normal: Recording normal-quality images
Quick 2: Quick recording normal-quality images
(recording the quick access images and search
images only)
Quick 1: Quick recording (recording the quick
access images and search images only)
Rec Mute: To reduce the recording time, set this to
"On". If this is set to "On", the monitor is blanked
("muted") during recording. If this is set to "Off",
the monitor is not blanked ("muted") during
recording.
Flush: Set the time delay after recording an image
until recording the image information. The setting
values are 0, 13 seconds, 23 seconds, 33 seconds,
1 minute, 3 minutes, 5 minutes, 10 minutes, and
unlimited (∞).
If you select a value other than 0, pressing the
following buttons or keys makes it possible to
start recording the image information.
• EXEC button or EXE key
• PLAY button/key (Playback starts after the
image information is recorded.)
• EJECT button (The disc is ejected after the
image information is recorded.)
• IMAGE button/key. (The image index appears
on the screen after the image information is
recorded.)
Capture Trig: Used to select the method by which
recording is controlled.
FS2: Use a 1-contact foot switch (connect to the
FS2 connector). When this option is selected,
also set the next item, "FS2 Mode".
..........................................................................................................................................................................................................
1) EE (Electric to Electric) signal: A signal which is input to
the recording circuitry, but passes to the outputs having
gone through electrical circuits.
42(E)
or
˘
or key.
˘ ≥
Camera1: Using a DXC-930 series/950 series
(DXC-960/970MD for medical use) Video
Camera (RGB/SYNC connection), record in
long exposure mode. (The setting of "Sync on
Green" in the Source Setup menu
automatically becomes On.)
Note
Before selecting Camera1, put the DXC-930
series/950 series (DXC-960/970MD for medical
use) Video Camera into slow shutter mode. It is
impossible to control the DKR-700/700P with the
camera in a normal mode. If Camera1 should be
selected during operation with the camera, turn off
the camera and change camera settings.
Camera2: Using a DXC-950 series (DXC-
970MD for medical use) Video Camera (RGB/
SYNC connection), record in the flash
synchronized mode. (The setting of "Sync on
Green" in the Source Setup menu
automatically becomes On.)
Note
When selecting Camera2, set the camera to flash
mode.
Ext1/Ext2: Using some other connected external
equipment to control the capture trigger.
FS2 Mode: Selects the operation mode when using a
1-contact foot switch.
Capture/Rec: Begin recording an image as soon
as it is captured to memory.
Capture: Just capture images to memory.
Alternate: Capture an image to memory with the
first operation, and write it to disc on the
second operation.
Frame/Field: To capture images in memory and
record on the disc in frame units, select "Frame."
To capture images in memory and record on the
disc in field units, select "Field." If using a field-
transfer camera with synchronized flash, select
"Field."