Playing One Image At A Time - Step Playback - Sony DKR-700 Mode D'emploi

Playing One Image at a Time
— Step Playback
This section describes the operating procedures to be
followed using either the DKR-700/700P front panel
or the RM-C700.
2
1
1
1
Make the following settings in the Play Setup
menu.
"Mode" setting
When high-quality is demanded (main
image display): Select Main.
When quick access is demanded (quick
access image display): Select Quick.
If Auto is selected, the both quick access image
and main image are played back.
On the DKR-700P, playing back a quick access
image results in a black frame around the image.
Note
When playing back a main image (i.e. either Main
or Auto was selected in step 1), and when the
image to be displayed was stored uncompressed
(by setting the "Quality" to Non Comp in the
Capture & Rec Setup menu), it may take a few
moments for the image to be displayed. (During
this time, no image will appear on the screen.)
3,4
2
3,4
"Play Mute" setting
To reduce the time until the image appears:
Set this to "On." When the image is
changed the screen will go blank (i.e. be
"muted").
If you do not wish to blank (i.e. "mute") the
image changes: Set this to "Off." The time
taken for the image to appear will be longer
than when you use the "On" setting.
For menu settings, see page 43(E).
2
Press the PLAY button/key.
The DKR-700/700P starts playback (the PLAY
button lights).
If you selected "Quick" in step 1, the quick access
image appears, and if you press the PLAY key
once more during playback the main image
appears.
3
Press the [+] or [–] button/key.
When the [+] button/key is pressed: An image
with larger-number is displayed.
When the [–] button/key is pressed: An image
with smaller-number is displayed.
Note
If there are images already recorded on the disc
with a different type of device, the image numbers
may in some cases not be consecutive.
4
Repeat step 3 to display other images.
27(E)