Functions Of The Basic Screen; Standard Mode - sylvac D200S Manuel D'utilisation

5 Functions of the basic screen

5

.1 Standard Mode

Menu Name of Part
Indicator of tolerances (global)
Version of the connected unit
Enables / Disables
Dynamic mode
Initializes
the dynamic mode
Activates
the Preset value
Send the values to
E xcel/Notepad file
C hange the unit
mm or inch
C hange
R esolution
Activates
Setup
Activation of General Setup
* Right - button of the mouse
Allows the selection of direct measurement or measurement in dynamic
mode . On each return in min/max mode the memories of minimum and
max im um are re-initial
ma x im um starts from
activated.
Reinitializes memo
using a probe. A new minim
fun ctio n is available also
d ynamic mode.
Allows to Enable/Disable all the functions of the Bar tasks. No more
Icons with function. It is also possible to disable the functions of the
s oftware and use them with the external contacts only.
Send the values to Excel/NotePad/file (see chapter 4.1.5).
It also allows to start /stop the automatic data acquisition if it has been
s elected (see chapter 4.1.1 «Sub-menu RS232 Setup»).
T he icon becomes green if the automatic data acquisition is functioning.
Allows the interruption of min/max measurements. The min/max values will
not be saved as long as the mode «Pause» is active. This function is only
displayed when the min/max mode is active.
Indicator Indicator
measure n° Tol.Low
Individual activation of each channel
ized with the value measured by the probe. The minimum and
t his point. The icon becomes green when the min/max mode is
ries of minimum and maximum to the value measured
um or maximum is done from this point (this
using the external contact). This function is active only in
Value of measurement
Indicator
Indicator
+/- Preset
97
E
Bargraph display
Activates/deactivates the
function keys
Enables/ Disables
the connection
Indicator of Channel n°
Indicator Indicator
Measuring mode Tol.Upper