Calibration Of The Unit - sylvac D200S Manuel D'utilisation

7 Calibration of the unit

The calibration of unit D200
necessary, pr oceed as follo
1 ) Fix the probe P2, P5, P10, P25 or P50 on a
vertical sup port.
2) Select a resolution of 0 001 m
0.000 01 in.
3) The probe complete
setting
4 ) Position the probe mech nically on the
reference base so th
indicates a value in
For a P2
P5
P1 0
P25
P5 0
5) Open "Channel Setup"
master which will be used for the calibration.
6) Move the probe on its re
7) Move the probe to the ca
repeat if necessary poin
8) Save the calib ration into
(see. chapter 4.1.12).
S is made by
ws:
.0 m or
ly op en, perform a zero
a
at t he display
cluded:
between 0.2 and 0.3 mm
betwee n 0.7 and 0.8 mm
between 0.4 and 0.5 mm
betwe n 0.8 and 0.9 mm e
betwee n 1.0 and 1.2 mm
and introduce into the field "Ref1" the exact value
ference base (value 0), then click
libration master then click again calibration.
ts 5), 6) and 7) for the other channels.
the unit by using
the manufacturer. If a re-calibration is
the menu "Transfer + Save"
107
of the
calibration.
E