Code For Remote Commands - sylvac D200S Manuel D'utilisation

6.2 Code for remote comma
Code
?
?X
X : 1-8
?X-Y
X, Y : 1-8
ResolX
X : 1-4
MM
IN
Lcal ?
Ncal ?
CDirX1X2X3X4X5X6X7X8
X1,X2...,X8 : 0 or 1
X1 configure channel 1
X2 configure channel 2
.....
X8 configure channel 8
CModX1X2X3X4X5X6X7X8
X1,X2,...,X8 : 0 or 1
X1 configure channel 1
X2 confi gure channel 2
....
X8 configure channel 8
T+xmmm.mmmm
x : channel n° (1 to 8)
m : upper Tol.
T- xmmm.mmmm
x : channel n° (1 to 8)
m : lower Tol.
nds
Function
P rint out of the displayed value (8 Channels.)
The unit sends the value of the selected channel
(e .g. : « ?6 » the value of channel 6 will be sent)
T he unit sends the values of the range of the
selected channels.
(e.g.: « ?3-6 » the values of channels 3 to
s ent)
Change the resolution
4 : 0.0001 mm or .00001 in
3 : 0.001 mm or .0001 in
2 : 0.01 mm or .0 01 in
1 0.1 mm or .01 : in
A tive the millim c e tre unit
Active the inch un it
Display the date o f the last calibration
Display the date of th
Change the measuring direction per channel
0 : positive
1 : negative
(eg : « CDir000101 00 » the measuring direction is
positive for channels 1,2,3,5,7,8 and ne
t he channels 4,6)
Change the mode of measurement internal or
e xternal
0 : ext
1 : int
( eg : Cmod1 0101010 » configure channels 2,4,6,8
in external measurement and channels 1,3,5,7 in
internal measurement)
I nsert the upper tolerance on ch
(eg : « T+30.0016 », the upper tolerance of
channel 3 is 0.0016 mm)
Insert the lower tolerance on channel X
(eg : « T-3-0.0013 », the lower tolerance of
channel 3 is -0.0013 mm)
104
e next calibration
gative for
annel X
E
6 will be