Checking Of Frontal Led Indicators - sylvac D200S Manuel D'utilisation

3

.5 Checking of Frontal LED indicators

After the complete installation, the "LED" power should b
th e case, switch OFF theD200S unit, wait 10 seconds and switch ON the unit again.
LE D Colour
Power green
Activities USB green
Tolerances red
global status <
Tolerances green
global status =
Tolerances yellow
global status >
Note: The "LED" "Activities USB" flickers only when data are sent or received via the
USB connection, it does not flicker if via the RS232 cable.
O nce that all is installed correctly, start the application.
The following window appears:
The configurations introduced after the first use are saved to each exit of the
software, thus the user finds the program in the same status after each use.
Description
the D200S unit is connected to the sector and ready.
Indicate that the data are received / transmitted via
USB connection.
Indicate that measurements are out of tolerance
(not re-workable)
Indicate that measurement are in tolerance
Indicate that measurements are out of tolerance
(re-workable)
84
e ON permanently. If it is not
(good)
E