sylvac D200S Manuel D'utilisation page 105

P+xmmm.mmmm
X : channel n° (1 to 8)
m : Preset value
TNxmmm.mmmm
x : channel n° (1 to 8)
m : Nominal value
Pr1
Syn
FactRes
EXTX (External contact),
SW1X (Switch 1),
SW2X (S witch 2)
X : a, b,c,e,f,g,h,i,j,k,l,m,n,seq1,
seq2,...,seq8,_NOFCT
MtlX
X : <,=,>
OutX
X : 0,1
Insert the Preset value on channel X
(eg : « P +516.150 », The Preset value of channel 5
is 16.15 0 mm)
Insert the nominal value on channel X
(eg : « TN616.150 », the nominal value of channe
6 is 16.150 mm)
Program the flash memory
Synchroni zation: return the configuration of the
u nit.
C harge the factory setting configuration.
Configure the concerned contact
a = Print
b = Preset
c = Change digital output setting
e = Clear
f = D110 lifting
g = Hold enable
h = Pause enable
i = Hold disable
j = Hold toggle
k = Pause disable
l = Pause toggle
m = D110 lowering
n = D110 toggle
seq1,...,seq8 = Print seq1...8
_NOFCT = No function
(ex: « EXTa », the external contact is configured in
print mode, the action of the contact sends the
data to the PC.)
See chapter 4.1.4
Modify the status of tolerances LED'S
(eg: « Mtl= » , Switch ON the green led tolerance
of the D200s unit)
Configure the digital output
0 : canal tol
1 : Master tol
(eg : « Out1 », the digital ouptputs are configured
in Master Tol, see chapter 2.3)
105
E
l