Communication Protocol (Remote Commands); Example Of Communication With Software Winwedge 32 - sylvac D200S Manuel D'utilisation

6 Communication protocol
The unit can work without the software D200S. The D200S unit can receive retro-
commands and thus modify the para
serial software of communication (e.g. Winwedge...) to fulfilled simple functions or to
create his own software.
The D200S unit transmits by using the following parameters:
Baud rate 19'200
Stop bit 2
D ta a bit 8
(No parity)
P arity

6.1 Example of communication with software Winwedge 32

(remote commands)
meters of its configuration. The user can use a
Start the software Winwedge 32
Select the port used
Example : COM4
Select the communication
parameters.
Baud Rate : 19200
Parity
Data Bits
Stops
Flow Control : None (Non)
Then click OK
Select "Analyze"
Enter into the window "Outp
the remote command «
followed by « CR » carriage r
ASCII (13)
to display the
of the D200S unit
Click on SEND icon.
In the window Input Data
of the connected channe
displayed.
103
: None
: Eight (8)
: 2
ut"
? » print
value of the 8 channels
, the values
ls are
E
eturn