Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 Use
of software D200S
4.1 The Main Menu
S
witch 1 Setting
T
his sub-menu allows you to choose
c
onnector)
S
witch 2 Setting
T
his sub-menu allows you to choose
c
onnector)
D
igital Output Setting
T
his sub-menu allows you to select th
T
ol&D110 or Channel Tol.)
S
imulation Mode
T
his mode allows to simulate the ex
d
igital outputs.
S
end to
T
his sub-menu allows selecting the d
p
rograms (Excel...)
O
pen File
T
his sub-menu allows you to open a
S
ave As...
T
his sub-menu allows you to save a
O
pen Configuration (From D200S)
T
his sub-menu allows you to activate
T
ransfer (to D200S)
T
his sub-menu allows you to transm
th
e D200S unit.
T
ransfer + Save (to D200S)
T
his sub-menu allows you to transmi
th
e D200S unit.
R
eset Unit
T
his sub-menu reinitializes the D200S
Access to the sub-menu
Click the right key of th
of the displayed values). The main menu allows you
to configure the
whole of your personal data.
RS232 Setup
This sub-menu allows to select the parameters o
RS232 (Ports.COM..)
Channel Setup
This sub-menu allows selecting the parameters of
measurements per channel.
Sequences Configuration
This sub-menu allows selecting the programming
mode of several sequences of measurements by
using differe
nt channels.
Foot Pedal Setting
This sub
-menu allows selecting the function of the
external contact (foot-pedal).
the function of Switc
the function of Switch 2 (Digital ou
e mode of measurement to be used. (Master
ternal contacts
and to visualize the status of the
estination of the data to various software
saved file (* syl)
file (* syl)
the saved configuration in the D200S unit.
it temporarily the configuration of the software in
t and save the configuration of the software in
unit.
86
e mouse in the gray zone (out
h 1 (Digital output
tput
E
f
Publicité
Chapitres
Table des Matières
