Use The Flash; Important - Minox DSC Notice D'utilisation

Switch Off the Display
Switch the Display On/Off button to the OFF side.
The Display will turn off but the Spycam remains
in power-on state.

Use the Flash

Charge the Flash
Switch on the Spycam in Camera mode. Press
the UP button on the Spycam once to enable
the flash. When the flash is enabled, the flash unit
will be charged automatically. The green shining
LED indicates that the flash is charged.
Trigger the Flash
When the flash is fully charged the green LED
lights on and shows the readiness of the flash.
Press the Shutter button on the Spycam to trig-
ger the flash.
Notes
1. The Display On/Off button enable the display
on/off only and has no effect on flashing.
2. The Flash Unit have no flashing and display if
it is not connected to the Spycam.

Important:

The White Screen appears over several se-
conds
Whenever the Flash unit is connected with the
DSC, the White Screen appears over several se-
conds. This indicates either the battery is low or
a contact problem with the DSC. Disconnect the
Flash unit with the DSC, charging up the flash
battery will fix the battery low problem. For the
connection, re-inserting the DSC properly will fix
the problem.
37