Shooting Photos - Minox DSC Notice D'utilisation

Shooting photos

Framing the subject and shooting the picture
Set the mode dial to the de-
sired Photo mode. With con-
nected and switched on flash
module the - symbol ap-
pears on the monitor.
Frame the subject you want to shoot through the
viewfinder or in the monitor of the connected
flash module. Press the shutter release to capture
and save the picture.
The LED display extinguishes during the shot and
the respective saving process. The LED display
then lights up blue again to signal that the DSC
is ready to take the next shot.
Using the flash
Activate the flash function in the Photo mode
by pressing the Up button. The LED display now
lights up violet (red and blue) to indicate that
the flash is ready.
When switched on the flash is controlled auto-
matically and only operates when there is insuf-
ficient light.
If the flash is not connected the LED flash in the
camera is used. This is immediately ready for use.
When the flash module is connected, this flash is
used instead of the internal LED flash.
After switching on the flash function the green
lamp (LED) on the flash module lights on to indi-
cate that the flash is ready for operation. The time
it takes to signal that the flash is ready can vary,
depending on the charge status of the built-in
battery. Press the Up button again to deactivate
the flash function, the LED display lights up blue
again.
39