Preparation
Strap bracket
Power switch button
36
Attaching Neck straps
Å
Put the string attached to the
strap through a Strap bracket
and let the strap go through
the loop as shown.
Ç
After attaching a strap to both
brackets (right and left) put
the straps together and adjust
length as shown.
Turning on and off
the power
Push the Power switch button to turn
the camera on. WELCOME sign ap-
pears on the monitor. Another push
on the button turns power off.
Power will be cut when the power
source button is depressed continu-
ously while the power source but-
ton is turned on.
* When the camera is idle for longer
than 60sec, power will automati-
cally be turned off.
Warning battery status
When the battery is almost drained,
the battery icon gives a warning
signal by blinking (
the battery at this point with a new
one is recommended.) Then, before
the battery is completely drained,
the icon fl ashes (
power is automatically turned off.
* When you do not use the camera
for a long time, be sure to remove
the battery from the camera in
order to prevent battery drain.
Shifting modes
Pushing Mode shift button will al-
ternately shift the mode between
Record and Playback.
* You cannot shift to Playback mode
when no image is stored.
Mode shift button
). (Replacing
) and the
37