Guarantee; Parts Subject To Tear And Wear; Safety Regulations; Correct Use / Application - Solo Port 423 Instructions D'emploi

Guarantee ; Parts subject to tear and wear ; Safety regulations
SOLO guarantees problem-free quality and will assume the costs for defect remediation by replacing the
defective parts in the case of material or manufacturing defects that occur within the guarantee period after
the date of purchase. Please note that specific guarantee conditions apply in some countries. Ask your
sales person if you have any questions. As vendor of the products he is responsible for the guarantee. We
request your understanding that no guarantee can be assumed for damages due to the following:
• Non-compliance with the operating instructions.
• Neglecting required maintenance and repair work.
• Damages due to improper carburetor adjustment.
• Normal wear and tear.
• Obvious overload through persistently exceeding the upper performance limits.
• Using non-approved tools.
• The use of force, improper handling, misuse, or accident.
• Damages caused by overheating due to dirt build up on the ventilator casing.
• Unauthorized modification or changes made to the device.
• Intervention by non-specialized persons, or improper repair attempts.
• The use of unsuitable replacement parts or parts other than SOLO original parts to the extent that they
cause damage.
• Using unsuitable fuel or fuel that has been stored too long.
• Damages that can be traced to implementation conditions from the rental business.
Cleaning, care, and adjustment work are not recognized as guarantee performances. All guarantee work
must be carried out by a SOLO dealer.
Various parts are subject to application- specific or normal wear and must be replaced in good time, when
required. The following parts are subject to normal wear and are not covered by the manufacturer's

guarantee:

• Air filter
• Fuel filter
• All rubber parts which come into contact with fuel
• Spark plug
• Starter

4.1 Correct use / Application

This machine must only be used for the purpose of applying approved plant protection agents, pesticides,
insecticides, weed killer (herbicides) and liquid fertilizers available from authorised specialist dealers as
well as for the purpose of applying clean water
Observe all instructions provided by the spraying agent manufacturer.
We recommend using only spraying agents that have been approved for use as spraying agent for the
above mentioned areas of application by the relevant authorities in your country.
The pressure sprayer must not be used for any other purposes, e.g., for the spraying of liquid paint or
applying any other media than the above mentioned liquids!
Particularly, aggressive, acid- or solvent-containing liquids, disinfectants or impregnating agents and
flammable products must not be sprayed with this device!
Within certain limits, the amount to be applied is subject to the position of the spray tube. During
operation, if the spray tube is directed upwards at an angle of more than 30° to the horizontal, use the
liquid pump that is available as a special accessory.
According to its type designation, this equipment is suitable for:
Agriculture, horticulture, orchards, green spaces, vineyards, nurseries.
The mistblower may only be used for the jobs it has been designed for – and no other!
Always observe all safety hints while using the machine.
ENGLISH 4
2. Guarantee

3. Parts subject to tear and wear

4. Safety regulations