Set-Up Chapter 1; Set-Up - Heidolph LABOROTA 20 eco Mode D'emploi

Carefully unpack all parts, inspect for missing parts by packing list.

1. Set-up

•
The LABOROTA 20 eco with its transportation rods
(4) is bolted to the pallet. Remove these screws and
carry the unit to its place of installation (CAUTION: 2
persons needed; in this configuration, unit's weight is
about 100 kg).
•
Place the LABOROTA 20 eco on a stable level
stand. In ready-to-go configuration, unit's weight will
be about 140 kg ! Ideal stand height above ground is
60 cm, this enables easy access to all controls. We
recommend the optional LABOROTA 20 eco base
(P/N 591-23300-00 (1)).
•
Remove transportation rods (4) and keep for later
use.
•
Through-holes for carrying rods are plugged with
caps (5).
•
Install protective cabinet (6) on table (7), opening
pointing towards operator. Use screws (8) pre-
installed in attaching holes.

SET-UP CHAPTER 1

45
iEi
6
8
7
4
5
1