Din En Iso 12100 Din En 1953 Din En 1127; D- 42327 Wuppertal; 24 531 - WALTHER PILOT III 2-K Instructions De Service

Contents
Exploded Drawing
Declaration of CE-Conformity
Listing of Replacement Parts
1 General Information
1.1 Identification of Model Version
1.2 Normal Use
1.3 Improper Use
2 Technical Description
3 Safety Instructions
3.1 Identification of safety instructions
3.2 General Safety Instructions
4 Connection of Input Lines
5 Operation
5.1 Safety Instructions
5.2 Requirements at the Start and Finish of Operation
5.3 Spray Pattern Test
5.4 Spray Pattern Adjustment
5.5 Retooling the Spray Gun / Repairs
6 Cleaning
6.1 Safety Warnings
6.2 General Cleaning Procedure
6.3 Routine Cleaning
7 Troubleshooting
8 Disposal of Cleaning and Servicing Substances
9 Technical Data
2
21
22
24
24
24
25
25
25
25
26
26
27
27
27
28
28
29
30
30
31
32
32
33
33
20
Declaration of Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility
that the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us
.
Manufacturer
WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Two-Component-Manual Spray Gun PILOT III 2-K
PILOT III 2-K
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100
DIN EN 1953
DIN EN 1127-1
Specification according 2014/34/EU
Category 2 Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal

Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006/42/EC.
Wuppertal, the 2nd of November 2016
p.p.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
V 24 531
DIN EN 13463-1
DIN EN 13463-5
Tech.File,Ref.:
II 2 G c T 6
2410
21