Charge The Battery; Conservation Charging; Trickle Charging - Fronius Acctiva Easy MC 04 Mode D'emploi

Charging
General remarks
Charge the To start charging, proceed as follows:
battery
1.
2.
3.
4.
5.
6.
7.
Conservation The charging circuit being used changes over automatically to conservation charging
charging once the battery is fully charged. The charging circuit continuously displays the fully
charged symbol (4 bars).
Charging a deep- If there is nothing on the charging circuit display during test mode, the battery is in deep
discharge battery discharge. The charging circuit recharges deep-discharge batteries with gentle pulses
over a long period. Disconnect battery from vehicle power supply/consumers before
charging.
Important! Only reconnect the battery to the vehicle power supply after:
-
-

Trickle charging

With trickle charging, consumer loads (e.g. lights) may be used during the charging
process. Note that
-
-
WARNING! Risk of explosion from short circuits and arcs. Before connecting
to/disconnecting from battery, disconnect charging circuit from mains supply.
During operation, check that charging terminals and battery poles are properly
connected.
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
Switch off engine and ignition, shed all loads
Connect (+) charging terminal to positive pole (red) on battery
Connect (-) charging terminal to negative pole (black) on the battery, or to vehicle
body (e.g. engine block) in the case of vehicle power supplies.
NOTE! When disconnecting, it is imperative to follow the above instructions in
the reverse order in order to avoid short circuits and arcs.
Charging circuit displays battery open circuit voltage
On the charging circuit being used, move charging circuit switch to the „I" position
Charging circuit starts to charge
Display on the charging circuit being used shows the current charge level as a
sequence of bars
20%
the battery has been charging for at least one hour
the battery is at least 50% charged (2 bars)
the power used over a long period is less than the charging current
the charging period is extended and the safety cut-out might therefore be activated.
50% 80%
4
100%