Taking The Sprayer Out Of Service And Putting It Into Storage; Maintenance Plan - Solo 456 Instructions D'emploi

5.7 Taking the sprayer out of service and putting it into storage

Prepare the device for storage according to section 5.6.
Store the device protected from sunlight in a secure, dry and frost-free location under a maximum ambient
temperature of 35 °C [95 °F].
There must not be any open fires or similar nearby.
Ensure that the unit cannot be used by unauthorised persons, in particular children.

5.8 Maintenance plan

Entire pressure sprayer
Hoses and their screw
connectors
Spraying agent tank
Nozzles and
filter element
Cap gasket
Pump piston sealing ring Grease (section 5.5)
Never start working if there are any irregularities or leaks, if you can see any damage to the equipment or
if the equipment is not working properly in any way. In this event, immediately depressurise the device by
pulling on the pressure relief valve (Fig. 3) and have it checked by a specialist workshop.
Before pulling on the pressure relief valve (4), the device must always be in an upright position.
Attention: Keep the device away from your face!
If you have any questions please refer to your authorised SOLO dealer.
Check whether the device is safe to use:
x Visual inspection of the device
x Check the tightness of all equipment compo-
nents (at maximum permissible pressure with
open and closed shut-off valve)
x Check the function of all active components
(pressure relief valve, shut-off valve, pump
handle, pressure gauge (depending on the
model))
Visual inspection
Visual inspection
Clean (section 5.6)
Clean (section 5.6)
Trial run to check the spray nozzles and the
filter element by measuring the delivery rate
(section 5.2)
X*: A monthly trial run is required only if the
device is used frequently.
Grease (section 5.4)
5 Maintenance, cleaning and storage
X
X
X
X X
X X X
X
X
X
ENGLISH 11
X* X
X