Attaching The Battery Charger Mounting Bracket To The Wall; Attaching The Battery Charger To The Mast Assembly - Invacare Roze Manuel De L'utilisateur

Attaching the Battery Charger
Mounting Bracket to the Wall
NOTE: For this procedure, refer to FIGURE 2.5.
1. Place the battery charger mounting bracket on the wall
at the desired position.
2. With a pencil, mark the middle hole position.
3. Measure down 6½ inches/16,5 cm from the pencil mark
and drill one mounting hole.
4. Install the bottom mounting screw until there is an
approximate 1/8-inch gap /3 cm between the screw head
and the wall.
5. Put the battery charger mounting bracket onto the bottom
mounting screw.
6. Drill the other two mounting holes.
7. Screw the mounting screws through the battery charger
mounting bracket and into the wall. Tighten securely.
CAUTION
Make sure there is an audible click when
mounting battery on the battery charger to
confirm proper mounting. Otherwise, injury or
damage may occur.
8. Put the battery charger in place on the mounting bracket.
9. Plug the battery charger into an electrical outlet.
NOTE: An LED will illuminate when power is applied to battery
charger.
Mounting Bracket
Mounting
Screws
FIGURE 2.5 Attaching the Battery Charger Mounting Bracket
Part No. 1164940
BOTTOM Mounting Screw
to the Wall
Attaching the Battery Charger to the
Mast Assembly
If the battery charger is attached to the mast
assembly and is plugged into a wall outlet, make
sure to unplug the battery charger from the wall
outlet BEFORE using the patient lift. Failure to
unplug the battery charger may result in injury
or damage.
NOTE: For this procedure, refer to FIGURE 2.6.
1. Remove the two mylar pieces covering the mounting
holes on the back of the mast assembly.
2. Insert the hook screws into mounting holes.
3. Tighten the hook screws.
4. Mount the battery charger mounting bracket on the hook
screws.
5. Charge the battery. Refer to Charging the Battery on
page 16.
FIGURE 2.6 Attaching the Battery Charger to the Mast
13
SECTION 2—ASSEMBLY
WARNING
Battery and Battery
Charger shown in place
on mast assembly
Assembly
Roze™Stand Assist Patient Lift