Lifting The Patient - Invacare Roze Manuel De L'utilisateur

SECTION 4—LIFTING THE PATIENT
4. Lower the lift for easy attachment of the sling.

Lifting the Patient

DO NOT exceed the maximum weight limitation (SWL) of 200 kg (31 stone). Maximum patient
weight is 195 kg (30 stone).
Individuals that use the stand assist sling MUST be able to support the majority of their own weight,
otherwise injury may occur.
DO NOT lock the rear casters of the stand assist lift when lifting an individual. Locking the rear
casters could cause the stand assist lift to tip and endanger the patient and assistants. Unlocking the
rear casters during lifting procedures allows the lift to stabilize itself while the patient is initially lifted
from a wheelchair, bed of any stationary object.
DO NOT move the patient if the sling is not properly attached to the attachment points on the stand
assist lift.
Make sure that the sling is properly attached BEFORE lifting the patient. If any attachments are not
properly in place, correct the problem. When the sling is elevated a few inches/cm off the stationary
surface and before moving the patient, check again to make sure the sling and all attachments are
securely in place. If any problem is found, lower the patient back onto the stationary surface and
correct the problem - otherwise, injury or damage may occur.
Adjustments for safety and comfort should be made before moving the patient.
NOTE: For this procedure, refer to FIGURE 4.2 on page 19.
NOTE: The patient MUST be in a seated position first. Use the head section of the bed to get the patient upright then move legs over the side
of the bed.
1. Instruct the patient to hold onto the hand grips on both sides of the stand assist lift (Detail "A" of FIGURE 4.2).
2. Instruct the patient to lean back into the standing or transfer sling.
Roze™Stand Assist Patient Lift
UP Button
Legs Open Button
FIGURE 4.1 Hand Control Buttons
WARNING
DOWN Button
Legs Close Button
Hand Control
18
Part No. 1164940