Operation And Controls - Heidolph TITRAMAX 100 Mode D'emploi

E
3.3. VIBRAMAX 110 / test tube adapters
Test tube are seated on the rubber mat by hand.
Several test tubes may be shaken at the same time, using the optional test tube
adapters. These adapters are secured on the shaker table with wingbolts. Test tubes
are plugged into "collets".
Before connecting power cord with main outlet, make sure that:
-
-
Carefully close your flasks and select appropiate shaking intensity (if flasks remain
open) to avoid splashes and spillage.
We recommend to start with low shaking speed and gradually increase frequency
to avoid accidential shaking at high speed.

OPERATION AND CONTROLS

your item is designed for your local voltage and frequency (data plate on item).
master switch is set to "0" and all controls are in "min." position (turn CCW
completely); this way you avoid spilling fluids by too intense shaking action.
test tube adapter for 49 ea. dia.
12 test tubes, up to 80 mm
long (P/N 549-82000-00) or
test tube adapter for 36 ea. dia.
16 test tubes, up to 80 mm
long (P/N 549-83000-00)
18