Installing The Propeller; Installing The Engine Cowling; Installing The Fuselage Nose - Reely SKY F-16 ARF Notice D'emploi

i) Installing the propeller
Install the components on the propeller attachment (1) as shown in the adjoining
illustration.
Bear in mind that this model is equipped with pusher propellers. This is why the
propeller must be installed "the other way round".
j) Installing the engine cowling
Spray-paint the engine cowling black.
Push the cowling (1) over the engine from the back and fasten it using several
short strips of adhesive tape.
Push the preassembled propeller attachment (2) onto the engine shaft and
secure it using the two grub screws.
Make sure you use threadlocker when fastening the grub screws.
k) Installing the fuselage nose
Cut out the fuselage nose along the outlines.
Apply a few drops of 5-minute epoxy glue to the inside of the nose and push it
onto the fuselage. Make sure that the nose is properly aligned!
Figure 31
Figure 32
Figure 33
43