Installing The Receiver; Applying The Decals - Reely SKY F-16 ARF Notice D'emploi

Cut out the canopy along the outlines.
Spray-paint the canopy black.
Apply a few drops of 5-minute epoxy glue to the inside of the canopy and press
it onto the moulded foam part (1).
Caution!
The canopy may only be glued to the detachable moulded foam
part. Otherwise, the canopy cannot be opened anymore!
m) Installing the receiver
The receiver (1) is fixed in the rear of the cockpit using servo tape. The aerial
cable of the receiver must be installed to the outside to the end of the wing.
Make sure that the aerial cable cannot get caught in the propeller.
n) Applying the decals
Apply the decals according to the ascending numbers on the decal sheet. See image 39 on the next page for the exact position of the decals.
Figure 37
Figure 38
45