Elevator And Aileron Linkages - Reely SKY F-16 ARF Notice D'emploi

f) Elevator and aileron linkages
The plastic parts for the control linkage are located on the injection moulding
tree and must be carefully separated with a sharp knife.
Make two linkages as shown in the adjoining illustration.
Screw the clevises (1) onto the linkage so that the linkage is flush with the
clevis at the back.
Make a linkage as shown in the adjoining illustration. Before screwing on the
clevis (1), push a piece of Bowden cable of approx. 50 mm (2) onto the linkage.
Screw the clevises onto the linkage so that the linkage is flush with the clevis at
the back.
Hook the clevis (1) into the arm of the elevator linkage.
Glue on the piece of Bowden cable (2) on the bottom part of the fuselage in the
designated guide (3).
38
Figure 16
Figure 17
Figure 18