Installing The Drive - Reely SKY F-16 ARF Notice D'emploi

Hook the clevises (1) into the arms of the aileron linkage (2).
Hook the control linkages into the servo arms (1) and secure them with safety
clips (2).
Install the servo arms on the elevator servo (3) and the aileron servo (4).
g) Installing the drive
Solder the motor connecting cables (1) to the cables of the speed controller (2).
Insulate the cables provisionally and run a function test.
To do that, connect the battery to the speed controller and connect the speed
controller to the receiver system. Check the engine and its rotational direction.
The rotational direction is correct if the engine turns clockwise (looking at the
engine shaft from the front). If this is not the case, two of the three speed
controller cables must be swapped.
When the function test is successful, insulate the wires permanently with heat-
shrink tube put on before soldering.
Extend the battery connection cables (2) so that they reach into the cockpit of
the model.
Figure 19
Figure 20
Figure 21
39