Reely SKY F-16 ARF Notice D'emploi page 40

Glue the squared timber (1) into the plastic engine support (2) using 5-minute
epoxy glue.
From the back, install the engine on the plastic support using the provided
screws.
On the fuselage top part, glue the complete engine support (1) into the provided
groove using 5-minute epoxy glue.
On the fuselage top part, glue the rudder (1) into the provided groove using
5-minute epoxy glue.
Make sure that there is no gap between the components and that an exact 90°
angle is formed.
40
Figure 22
Figure 23
Figure 24