Cleaning Of Vertically-Oriented Sliding Doors - Spartherm Premium V-1V-87h Instructions De Montage

4.5.3 CLEANING OF VERTICALLY-ORIENTED SLIDING
DOORS
Cleaning should be carried out when cold and in accordance with the following
versions.
Opening of the fire door:
1. Close the firebox door (pull it fully downwards!).
2. Move the 'cold hand' from the left-hand side to the central locking position
above the firebox door.
3. The door can now be tilted up. Observe the specific instructions relating to
the Linear 3S and Linear 4S or Prestige version!
Undo the lock by rotating it clockwise.
1. Move the 'cold hand' to the right-hand
side of the door and, positioning it on
the lock, turn the lock fully downwards.
GB 17
Linear 3S-Ausführung:
2. Press the 'cold hand' downwards at, at the same time, use the other hand
to hold up the fire door. That enables the door to tilt slightly. Now remove
the 'cold hand' from the support to prevent damage to the bench and to
prevent injuries. Now tilt the door fully upwards until it rests against its stop.
Linear 4S or Prestige versions::
1. With one hand on the door handle, gently tip the fire door downwards, at
the same time supporting it with the other hand.
The glass window can now be cleaned in accordance with the operating
instructions.
Closing the fire door:
1. Carefully close the fire door.
2. Move the lock above the door using the 'cold hand', turning the lock fully
backwards to its limit position. This is important since otherwise the lock
can scrape against the hood and the door will not seal properly
3. Test the function of the door by sliding it upwards and re-check the upper
lock to ensure that the locking mechanism is fully closed, i.e. at its limit
position.
Caution: When opening and closing the door, only touch the door frame.
Never exer t pressure on the window panels. (risk of
Now open the door fully
until it rests against its stop.
GB