Cleaning Of Round Or Angled Vertically Sliding Doors; Cleaning Angled Doors (The 3-Sided Arte Model) - Spartherm Premium V-1V-87h Instructions De Montage

breakage!)
4.5.4 CLEANING OF ROUND OR ANGLED VERTICALLY
SLIDING DOORS
Close the firebox door (pull it fully downwards). Place the 'cold hand' on the
sliding rail lock above the firebox door. (Caution! One-sided or two-sided,
depending on model)
With a clockwise turning motion, you slide the retaining bolt on the lock
through 90 degrees to the front (below the door cover).
Turn the locking mechanism clockwise in
order to lock the sliding rails.
Move the 'cold hand' to the right-hand side
of the door on the support/lock and turn it
fully upwards.
Swing the door open for cleaning purposes.
Closing the firebox door:
1. Close the firebox door carefully and keep it lightly pressed in.
2. Move the 'cold hand' to the right-hand side of the door and, positioning it
on the lock, turn the lock fully downwards.
3. Turn the locking mechanism anti-clockwise in order to free the sliding rails.
4. Test the function of the door by sliding it upwards and re-check that the
locking mechanism is fully closed, i.e. at its limit position.
After cleaning, re-close the firebox door, replace the 'cold hand' on the square
nut, close the door by pressing on the frame (not on the glass) and lock it by
turning the 'cold hand' fully downwards. Do not forget to reset the slide rail
locking mechanism.
4.5.5 CLEANING ANGLED DOORS
( THE 3-SIDED ARTE MODEL)
Cleaning must always be executed in a cooled-down state!
Opening of the fire door:
1. Close the firebox door (slide it fully downwards!).
2. Swivel out the locking mechanism on the sliding rail lock using the 'cold
GB 18
There is a second bolt on the opposite
side.