Delivery; Storage; Pump Returning Back To The Supplier; Intended Use - Wilo SCP Série Notice De Montage Et De Mise En Service

English
should be secured against slipping along with pro-
tective cover to prevent damage to the product,
paint and/or injury to personnel.
When lifting the pump in combination with the
bedplate, the lifting tackle should be attached to
the lifting lugs provided on the base plate side
member. To lift the pump the lifting slings should
pass beneath the pump body at suction and deli-
very flanges (see lifting diagrams - see also gene-
ral safety Information, chapter 2). These must
have sufficient load bearing capacity to ensure
that the product can be transported safely. Refer
figure 1 and 2

3.2 Delivery

On arrival, the delivered items must be inspected
for damage and a check made that all parts are
present. If any parts are damaged or missing, the
transport company or the manufacturer must be
informed on the day of delivery. Any claim made at
a later date will be deemed invalid. Damage to
parts must be noted on the delivery or freight
documentation.

3.3 Storage

3.3.1 Short-term storage (less than 3 month)
The equipments as shipped have adequate pro-
tection for short-term storage in a covered, dry
and ventilated location at the job site prior to ins-
tallation.
If the pump is not installed immediately after deli-
very, it must be stored in a dry and clean place with
sufficient ventilation, no vibration, no freezing
and the temperature variations must be smooth.
Bearings and couplings must be protected against
sand, dust and foreign bodies. To avoid corrosion
and jamming, please lubricate the pump and make
turn the rotating elements for several turns at
least once a week. Pre-packed desiccants may be
used to absorb moisture & keep the pump dry. It
must be removed before putting the pump on
operation.
48
3.3.2 Long-term storage (more than 3 month)
If the equipment will be subject to extended sto-
rage condition prior to installation, then the
manufacturer must be informed about storage
duration, so that special protection can be recom-
mended.
• Place the SCP pumps horizontally on firm founda-
tion and secure it against falling.
• The machine must be protected from direct sun-
light, heat, dust, and frost.
• The rotors or propellers must be turned at regular
intervals. This prevents the bearing from locking
and the film of lubricant on the mechanical shaft
seal is renewed.
• For mechanical seal, we recommend : relative air
humidity below 65%, temperature between 15°C
and 25°C. Direct exposure of the mechanical seal
to heat (sun, heating) as well as to ozone, present
or produced by ultraviolet light (halogen or fluore-
scent lamps), must be avoided because of the risk
of embrittlement of elastomeric materials.

3.4 Pump returning back to the supplier

Products, which are delivered back to the plant,
must be clean and correctly packaged. In this con-
text, clean means that impurities have been
removed and decontaminated if it has been used
with materials, which are hazardous to health.
The packaging must protect the product against
damage.
CAUTION! Guarantee not applicable!
Products, which are not suitably packaged for
delivery back, are no longer covered by guaran-
tee!

4 Intended use

The pump supplied is intended for specific fluid.
Refer pump data sheet and order confirmation. For
any change in pumped fluid refer Wilo beforehand.
Horizontal split Case pumps are used in water sup-
ply, water-circulating systems, injection water,
spray pond, air-conditioning, water treatment,
Sprinkler & drip irrigation, fire fighting, juices etc.
If the operating conditions are different of the
specifications given in the order, (i.e. type of
liquid, temperature or duty point), the end user
must ask a written agreement to Wilo on the new
operating conditions before starting the pump.
WILO SE 10/2019